Microsoft windows server 2003, microsoft windows 2000, and microsoft windows xp use a fixed mtu size of 1500 bytes for all ppp connections and use a fixed mtu size of 1400 bytes for all vpn connections. this is the default setting for ppp clients, for vpn clients, for ppp servers, or for vpn servers that are running routing and remote access.. How to change the mtu in windows server 2008 & 2012. to change the mtu to 1454 use this command. this command sends a ping using a 1500 byte packet size (mtu). you can slowly decrease the packet size, in increments of 10 or so, until you stop getting fragmented packet results. if the packet is too large, you will get “packet needs to. Change windows mtu size. 1. open a command prompt cmd (right click cmd -> run ad administrator) 2. type the following commands in order. netsh interface ipv4. 3. your command window will now be at the prompt to change mtu using the next command below. 4. finally, type the following command to change your windows mtu..
Thus, change of mtu is normally to reduce and reduce, but not to increase, the size of the mtu. if you want to change the mtu for ipv6 network interface, change the ipv4 in commands above to ipv6. after the change, reboot and restart the computer for the change to take effect.. The last successful value plus 28 will be your mtu value. in my case a packet size of 1430 succeeds but 1431 fails, so 1430 + 28 = 1458. step 3: set your mtu. now you have identified the interface you need to change and the ideal mtu for you, now it is time to make the change.. The mtu defines the packet size. different types of data or network links respond differently. to change the mtu on a windows server we’re going to use the netsh command. first, we’re going to use ping to ping a host on our network, using -f and then -l which allows us to define the mtu size..